Cabinet Planner
« help with doors »

Welcome Guest. Please Login or Register.
Mar 30th, 2018, 8:57pm



ATTENTION MEMBERS: Conforums will be closing it doors and discontinuing its service on April 15, 2018.
We apologize Conforums does not have any export functions to migrate data.
Ad-Free has been deactivated. Outstanding Ad-Free credits will be reimbursed to respective payment methods.

Thank you Conforums members.

« Previous Topic | Next Topic »
Pages: 1  Notify Send Topic Print
 thread  Author  Topic: help with doors  (Read 387 times)
n7kon
New Member
Image


member is offline

Avatar




PM


Posts: 7
xx help with doors
« Thread started on: Jun 23rd, 2017, 2:24pm »

I have a door opening that is 18 wide x 20 tall when I print out the parts sheet it shows the door rails at 15.75 rails. stiles are 2.375 wide with a .375 long tenon plus it shows a flat panel of 14.75 x 16.75 that panel would be too small for a 15.75 wide rail. I have door standards set for 2.375 widths on stiles and rails and the .375 tenon length.
When you do the math by hand the rails should be 15" for a .5 overlay. What do I have setup wrong?
User IP Logged

n7kon
New Member
Image


member is offline

Avatar




PM


Posts: 7
xx Re: help with doors
« Reply #1 on: Jun 23rd, 2017, 5:21pm »

ok took out cutting length in door standards and rails go to 15" but the panel is still 14 x 16 what changes do I make for the panel size?
User IP Logged

Rob
Administrator
ImageImageImageImageImage


member is offline

Avatar




Homepage PM

Gender: Male
Posts: 882
xx Re: help with doors
« Reply #2 on: Jun 24th, 2017, 8:18pm »

For most cases you want to leave the "tenon length" at zero and set the "stile & rail cutter" to .375

The tenon length setting is added to the rail length without adding to the panel width.

The stile & rail cutter setting will also adjust the panel with.
User IP Logged

Please remember this forum is for users to help each other. If you need a faster answer to a question email me directly.
n7kon
New Member
Image


member is offline

Avatar




PM


Posts: 7
xx Re: help with doors
« Reply #3 on: Jun 28th, 2017, 7:56pm »

Thanks, I knew it was something simple I was doing wrong.
User IP Logged

Pages: 1  Notify Send Topic Print
« Previous Topic | Next Topic »

| |

This forum powered for FREE by Conforums ©
Terms of Service | Privacy Policy | Conforums Support | Parental Controls